SAMPLE DESIGN CLIPS MADE FROM ALUMINIUM OR TIN /BRASS SHEET
ABOUT 6.5 CM LONG x 3 CM WIDE x .5 MM THICK

The designs will need to incorporate a "clip" section which can be pressed out from the design with the thumb so that the whole design can be used as a fancy " paper clip".

The clip section (which can be plain) will be clipped onto the rear edge of a sheet of paper allowing the front remaining part of the design to clip on to the front edge of a sheet of paper.

The clip section should be formed in such a way that when the design is clippped onto a piece of paper, the design on the face side of the paper overlaps the edge by 1 cm (there will be a 1cm border of tape glued to the edge of the paper and the clip should not protrude beyond the tape).

The remaining part of the design is folded around a stick as shown in the image below.

An example of the finished item is shown in the last image.